Digiprog III Digiprog3 V4.94 The Lastest Version Mileage Programmer Support More Vehicles

Digiprog III Digiprog3 V4.94 The lastest Version mileage programmer support more vehicles
 
Digiprog III Programmer with Full SoftwareWith the use of the new DIGIPROG III, the odometer adjustment is a breeze. Intelligent accessories and extensive manuals are enclosed.
 
V4.94 Add Model List:
 
Audi
-A3 new version
Ford
-F150 24C16
-Falcon 24c02
Mercedes 
-W176 new version
-W204 new version Diag
-w212 new version Diag
Opel
-Insignia new version
-Astra new version
V4.93 digiprog 3 odometer programmer:
 
For Audi
A3 Diag new version
A6 Diag new version
A8 Diag new version
For Mercedes
R 172 Diag new version
R 231 Diag new version
W 212 Diag new version
For Ford
Kuga Transit
For VW
Amarok Polo Johnson
 
 
 
Digiprog 3 Menu:
 
1. EEPROM Menu
 
The first option on the main menu is the Eeprom menu. Reading, writing and saving Eeprom information is all done using this menu. A more detailed guide to using this menu follows later on in the introduction.
 
2. CAR/TRUCK Menu
 
This is the menu you will use for correcting and reprogramming vehicles. Manufacturers are set out in alphabetical order and models of vehicles are set out in a simple sub-menu format.
 
3. Motorcycle Menu
 
This menu is the same as the CAR/TRUCK menu but is used for reprogramming motorcycles.
 
4. Special Functions Menu
 
The special functions menu is for use only by official DigiProg dealers.
 
5. Setup Menu
 
This menu is where settings on your DigiProg can be changed. Language, password, brightness, volume, and the time/date can all be set and changed in this menu. You can also change whether your machine is working in kilometres or miles.
 
Using the EEPROM Menu:
 
On some of the vehicles you will come across, an eight pin Eeprom chip will be used to store the vehicle data. These chips hold vital information from the vehicle such as ignition and immobiliser codes. Loss of this information could result in anything from minor faults, to major faults involving the vehicle not starting and having to be taken to the main dealer. This is why it is very important to read and save the original information from the Eeprom before programming, this way if any errors do occur you can always return to the point you started.
 
The process of reading and saving this information is very simple. The Eeprom chip itself will have a mask number printed across the top of it, for example a widely used chip is a 93C46. You can connect the chip to your DigiProg by using adaptor ST01 or ST04. Most chips are surface mount eeproms which will use 8 Pin SOIC Clip, but the larger DIL chips will use 8 Pin Dill Chip Clip.