LED Linear Light

SAFETY INFORMATION                                   
IMPORTANT:Read all safety precautions and installation instructions carefully before installing
 
1.Do not handle any energized fixture or attempt to energize any fixture with wet hand or while standing on awet or damp surface or in water.
2.Assure that the fixture is mounted onto a sound structurally surface that will support the fixture.
3.The fixture is designed for use in a 100-277VAC,60Hz fused circuit.Do not use on a dimming circuit.
4.Do not look inside the lights.
5.Product can be used in garages,basements,work areas,utility rooms and recreation rooms.
6.Maximum distance to the receptacle is depend on the length of the cord provided.
 (5 ft,2-prong,100-277V grounded plug included)
7.Use plug series connection method between lamps is convenient for installation,Suggest tube series
 connection quantity no more than 20pcs per time
8.The fixture is installed directly beneath a ceiling-mounted receptacle. Excess cord should be
  secured to one of  the supporting chains with a cable tie to keep it out of the work space.
9.Use hook to support chain,not the electrical cord.
10.Do not install on radiant-heating type ceiling.
 
WARNING:IF NOT FOLLOW THESE INSTRUCTION MAY LEAD TO A POTENTIALLY FATAL ELECTRICAL SHOCK OR PROPERTY DAMAGE
 
PRE-INSTALLATION                                          
Remove the fixture carefully from the carton and check to make sure that all hardware is included.
Be careful not to misplace the hardware needed for installing the fixture.Unwind string that binds power
cord for last step.
                                                  
 
NOTE:The unit is install directly beneath a ceiling-mounted receptacle.If excess cord ,bind with saved from Planning Installation or a cable tie to keep it out of work space.
 
ATTACH THE CEILING HOOKS
 
Choose ideal location of light fixture making sure it is within reach of an outlet.Use a pencil to place a mark on the ceiling where each ceiling hook(Part C) and screw(Prat D) should be.Screw hooks in place until secure.
 
 
ATTHCH THE "O" HOOKS
 
Insert the "O" hooks(Part B) into each of the holes on both sides
of the shop light.(Figure 1)
 
ATTACH THE HANGING CHAIN
Using two hanging chains(Part A) attach a hanging chain to one of the "O" hooks(Part B) previously attached to each side of the light fixture.(Figure 2)
2.Attach the remaining "O" hooks(Prat B) to the hanging chains and attach to the ceiling hooks.
3.Plug power cord into an outlet to use pull chain to power on.